IS type single stage single suction centrifugal pump Overview: IS type single stage single suction centrifugal clean water pump, suitable for industrial and urban water supply and drainage, can also be used for agricultural irrigation and drainage. It is used for conveying clean water or other liquids similar to water in physical and chemical properties. The temperature of the liquid to be transported is not higher than 80℃, and the inlet pressure is allowed to be 0.6mpa. Parameters: flow Q 5.4 ~ 400 m3 / h ~ 125 m lift h 4 types: IS100-65 - J - 200 - A IS -- single-stage single-suction centrifugal pump suction diameter (mm) of the 100-65 - vomit outlet diameter (mm) J - J says slow down using 200 - in the name of the impeller diameter (mm) A, A, B, C, respectively after the first, second and third time cutting impeller diameter structure: pump IS horizontal installation, horizontal axial suction, radial spit up. The pump is of suspension structure, and the inlet and outlet pipelines are not needed to be removed during maintenance. The rotor parts can be removed for maintenance. The pump is connected with the motor by the common elastic coupling or extended elastic coupling. The shaft seal of the pump is sealed with soft packing. The bearings are single row radial ball bearings, lubricated by lubricating oil. Direction of rotation: The pump rotates clockwise from the motor end. Main parts material: flow parts material is generally ordinary gray cast iron. Complete range: complete supply pump, motor, common base, coupling, etc., also provide bottom valve, check valve, gate valve. When ordering, please indicate the material of main parts, if you have special requirements for pumps and motors, you can negotiate with our company about the technical requirements.