IFZ screw pump Summary of IFZ screw pump: IFZ screw pump is an efficient non-plugging pump developed by ebara Corporation based on advanced technology. Compared with other sewage pumps, the pump has a high efficiency of about 25%. It is a kind of high efficiency and energy saving product. When treating high concentration liquid, the head drop is not obvious. It can be used to transport pulp, sewage, sewage and various mixed liquids containing short fibers, with the maximum diameter of particles of 40 ~ 104mm. The performance parameters listed in this catalog are obtained by test under the condition of clean water at room temperature (specific gravity is 1). The temperature of the medium is 0 ~ 80℃, the allowable inlet pressure is 0.098 ~ 0.196MPa(1 ~ 2kGF /cm2), and the maximum service pressure is 0.52 ~ 0.98MPa(5.3 ~ 10kGF /cm2). The performance parameters listed in this catalog are obtained by test under the condition of clear water (specific gravity 1) at room temperature. Parameter range: flow Q 29 ~ 1170m3/h Head H 3.6 ~ 68m Model Description: 150× 100IFZ-K 150 -- suction diameter mm, 100 -- discharge diameter mm (the same as the suction diameter is not indicated), IFZ -- screw non-plugging type pump, K -- head code. Structure type: the pump is installed horizontally, inhaled horizontally, discharged upward from the center, and supported by the feet of the pump body. The pump is a rear drawing structure. The pump body can be disassembled for maintenance without removing the piping at the suction inlet and outlet. Because of the special impeller, the miscible fluid with small bubbles can also be transported. The pump adopts packing seal or mechanical seal according to user's requirement. The direction of rotation, seen from the motor end, the pump is clockwise rotation. Main parts material: generally gray cast iron, but also according to the user needs to choose other materials. Complete range: complete supply pump, motor and base. When ordering, please indicate the material of impeller and sealing ring. If you have special requirements for pumps and motors, you can negotiate with the company about technical requirements.